I'ld like to interconnect 2 LAN in different building by a pair of AIR-1310G.The distance is very short (20m) but crossing a street in an urban environment. I want to know the best security configuration to use, I see the possibility of WPA-PSK but is it possibile to use LEAP betwenn the non-root bridge and the root-bridge
set your root AP up as a radius server. Define a username/password. This username/password will be used by the non-root ap.
Go into the non-root ap and configure your Encryption accordingly and configure the SSID to match the root ap. From the SSID manager page, there is a username/password field under "General Setup". Apply the username/password you define on the root ap.
As long as everything is configured correctly the connection should come right up. You can go as far as configuring EAP-FAST with WPAv2 if you would like.
I've configured EAP-FAST with WPA2 on a pair of 1310s. Can a EAP-FAST authentication be used on a wireless bridge comprising of two 1231 APs; the commands for EAP-FAST do not appear to be available on this platform?
What is the highest encryption that you can run on the link between two 1310 bridges (root-bridge and non-root-bridge) ? I tried using WPA with encryption cipher tkip and have endless problems keep up the link. And yes I am running the latest IOS on the bridges. Any idea on what would be a reasonably high encryption to use ?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...