I am looking for a way to set up an alarm through WCS if the Aeroscout engine running on the MSE 3350 goes down. In other words if the registered/active status of the Aeroscout CLE goes false/false or true/false, I should be notified?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...