Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Setting up Maps in WCS

I've exported my AutoDWG files to JPEG via AutoCad raster Print driver. The files look fine when viewed thru windows picture viewer.

I import them into a floor area, and they look fine there.

I start Map editor up, and they look HORRIBLE. I actually lose walls.

I'm running Version 3.2.40.0

I'm planning on upgrading as soon as I can, but is this an issue that was specifically fixed, or am I doing importing the image wrong.

Is there a recommended resolution they should be? Right now they are 1234 x 772 pixel images. I've tried with smaller images, and it just seems to get worse.

1 REPLY
Hall of Fame Super Silver

Re: Setting up Maps in WCS

I usually print it to a pdf then I screen capture (SnagIT) and crop the image. I then save it as a Windows Metafile Format. You can then import that into WCS.... or if that doesn't work, Save it again into a gif file. I will have to try it tomorrow.. can't remember but I know what you mean with the walls looking like junk!

-Scott
*** Please rate helpful posts ***
167
Views
0
Helpful
1
Replies