Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

snmp error

hello, I am using the ASA 5505 firewall. Recently ,i have enabled the snmp in the device so that i can monitor  the device through the monitoring tool.

So I installed the Cacti monitoring tool in my server. But the cacti is not showing the firewall graph. Instead, it is showing the SNMP error.

I am puzzled what to do .can anyone help me out ragarding this issue?

my snmp configuration is as follows:

snmp-server host inside x.x.x.x community secretword udp-port 161
snmp-server location Billing Room
snmp-server contact allen
snmp-server community *****
snmp-server enable traps snmp linkup linkdown coldstart
snmp-server enable traps syslog

Note: x.x.x.x represents the server IP address where i have installed cacti tool.

Regards,

Nisha

149
Views
0
Helpful
0
Replies