solution. Previously, we were able to monitor associated clients per AP and roll the data into MRTG & Cacti. Is there a way to do it with the airespace APs or controllers? The OID for the aironet was .126.96.36.199.188.8.131.52.2184.108.40.206.1.1.1 , but I was not able to find a similar one from a walk on one of our 4400 controllers
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...