Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP OID to get Serial Number

Hello,

Does any know the OID in order to extract the serial number from an access point? we are using 1230-B-A-K9 radios

1 REPLY
kka
New Member

Re: SNMP OID to get Serial Number

Walk ENTITY-MIB::entPhysicalSerialNum (1.3.6.1.2.1.47.1.1.1.1.11),

there are several entries: chassis, radio, ...

Part of entPhysicalTable for AP1242AG

ENTITY-MIB::entPhysicalDescr.1 = "Cisco Aironet 1240 Series (IEEE 802.11a/g) Access Point"

ENTITY-MIB::entPhysicalDescr.2 = "802.11G Radio"

ENTITY-MIB::entPhysicalDescr.3 = "802.11A Radio"

ENTITY-MIB::entPhysicalDescr.4 = "PowerPCElvis Ethernet"

ENTITY-MIB::entPhysicalSerialNum.1 = "FCZXXXXXXXX"

ENTITY-MIB::entPhysicalSerialNum.2 = "GAMXXXXXXXX"

ENTITY-MIB::entPhysicalSerialNum.3 = "ALPXXXXXXXX"

ENTITY-MIB::entPhysicalSerialNum.4 = ""

ENTITY-MIB::entPhysicalModelName.1 = "AIR-AP1242AG-E-K9 "

ENTITY-MIB::entPhysicalModelName.2 = "Radio AIR-AP1242GR:5M80.13"

ENTITY-MIB::entPhysicalModelName.3 = "Radio AIR-AP1242A:5M80.13"

ENTITY-MIB::entPhysicalModelName.4 = ""

OIDs numerically (entPhysicalSerialNum only)

1.3.6.1.2.1.47.1.1.1.1.11.1 = "FCZXXXXXXXX"

1.3.6.1.2.1.47.1.1.1.1.11.2 = "GAMXXXXXXXX"

1.3.6.1.2.1.47.1.1.1.1.11.3 = "ALPXXXXXXXX"

1.3.6.1.2.1.47.1.1.1.1.11.4 = ""

11836
Views
0
Helpful
1
Replies