SSH to router, then able to telnet to the next routers
I have setup my routers to allow only SSH (not telnet) access.
This is my setup
ip ssh time-out 120
ip ssh authentication-retries 3
line vty 0 4
login authentication LETmeIN
transport preferred ssh
transport input ssh
I am only able to SSH to any router, but once I login to the first router, I am then able to telnet (no SSH) to all other routers. Am I really using SSH protocol from the 1st router to the other routers OR did I misconfigure something?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...