I have a few 1131ag APs that I'm using in Autonomous Mode. I've configured and everything looks fine but the "mood ring" is yellow. I've worked with these previously in lightweight mode and know they should be green.
Got that thanks. I was wondering if the status is different depending on the modes. The only reference for yellow is problems with the Ethernet. However, I am able to connect to AP via ethernet so I know it is definitly working. I can config via console and http and the device doesn't have any other errors. What might be wrong or where do I look?
I guess POE could be the issue. The AP is using POE from the switch and appears to be working fine otherwise. I 'm trying to find anything or direction where to look for possible causes other than "Ethernet Link". I've even seen devices associating with the AP.
I swapped cables, turned off PoE and used the power cord but still not getting the green status on the top of the AP.
Another update: Everything appears to be functional with the AP. It would be nice if there were color samples to go with the chart. I've had others look and get a mixed bag of "It's yellow" and "It's green".
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...