Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Syslog config on controller for specific AP not sticking.

Hello Folks,

I have a Cisco 1510 AP associated to a controller. When I issue the command config ap syslog specific x.x.x.x, the Controller CLI takes the syntax and sends the log messages to the syslog server. However this does not last. Usually within 24 hours I will see messages in the syslog server that say "Setting logging to host 255.255.255.255", then the messages stop, obviously. I have tried this several times making sure to save the changes in the controller everytime. Any ideas

Thanks

-Chris

Everyone's tags (2)
291
Views
0
Helpful
0
Replies
CreatePlease to create content