Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Talk to workgroup bridge via AP?

I have an Aironet 350 access point and also a workgroup bridge. I can ping & communicate with the workgroup bridge's ip address for setup & diagnostics from the bridge's ethernet side, but I cannot see it from the wireless side, i.e., through the AP! I can see all the clients I put on the bridge through the AP, so I know both units are communicating with each other. Does anyone know how to talk to the bridge from the AP side? Thanks in advance.

1 REPLY
New Member

Re: Talk to workgroup bridge via AP?

I'm replying to my own post for the benefit of others. Mark emailed me the answer, which is that this is a known bug! This bug is described in:

http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCdu10993&Submit=Search

The solution is to upgrade the firmware in the AP to version 11.10.

221
Views
0
Helpful
1
Replies
CreatePlease login to create content