Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Tapping wireless traffic on a WiSM

All,

Is there any way to do a port span or tap of all traffic going to and from a WiSM?  You can't seem to monitor the port channel that goes into the controller.

Thanks

Jason

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: Tapping wireless traffic on a WiSM

Sure, you can set the port-channel interface as the source of the monitor session.

lab1sup720ip1(config)#monitor session 1 source interface ?
  FastEthernet     FastEthernet IEEE 802.3
  GigabitEthernet  GigabitEthernet IEEE 802.3z
  Port-channel     Ethernet Channel of interfaces

2 REPLIES
Gold

Re: Tapping wireless traffic on a WiSM

Sure, you can set the port-channel interface as the source of the monitor session.

lab1sup720ip1(config)#monitor session 1 source interface ?
  FastEthernet     FastEthernet IEEE 802.3
  GigabitEthernet  GigabitEthernet IEEE 802.3z
  Port-channel     Ethernet Channel of interfaces

New Member

Re: Tapping wireless traffic on a WiSM

Thanks,

I will meet with security on monday and see if it works.

It did kick out this error:


msndc-ssw1(config)#monitor session 1 source interface po417
% Monitor Session with Service Cards Port-Channel will not be nvgened

379
Views
0
Helpful
2
Replies
CreatePlease login to create content