I install >100 Lightweight AP (1131AG)in a School, we don't have any problem on deploy WLC and WCS (include multicast routing...). We don't have any problem for connect Macbook or laptop in wireless, but we have a problem for the macbook in loadblancing. In a Hall, it have 3AP in there, but when a lot of peoples group in a place one of the access point will be very busy, and the performance will be drop down, but it have 2AP near there(within 10-20M). It have a event log in WLC & WCS,
(AP "AP NAME", interface '802.11b/g'. load threshold violated), but it have 3AP in there.
We try to limit the no. of clients to associate but not work. I know Macbook is not CCX client, but anybody can help.
WLC Ver. 220.127.116.11
WCS Ver. 18.104.22.168
I know Cisco have a successful case for Cisco wireless and Apple Macbook in Empire High School
It depends on your AP coverage as well as client radio factors
from the url above
"Do not enable aggressive load balancing unless the network has available a high density of access points in the area, and never if there is voice over wireless. If you enable this feature with access points spaced to far away from each other, it might confuse the roaming algorithm of some clients, and induce coverage holes in some cases. In the latest software versions, this feature is disabled by default."
You can set the user limit per radio and load balancing will still occur seamlessly
We had try to limit the numbers of user in each RF interface in AP1131. e.g. I set one RF interface and limit for 10users used, but in the WCS and WLC, it display more than 10 macbooks is using the RF interface. We cannot stop the macbooks to associate the RF interface in the access point.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...