Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Trying to Configure AIR-CAP3602i from WLC Not working

Hi,

I posted a question similiar to this a few months back and got a repy that worked. So i tried the same thing this time but the AP is different this time.

I'm trying to change the RF Channel and Tx power level on my AIR-CAP36021-E-K9 from my WLC WISM2. I do the following;

Wireless --> 802.11 b/g/n --> Access Point --> Configure. I then select custom on both Power and Channel and make my change and then

click Save Configuration in the top righthand corner. I go back to 802.11 b/g/n select my AP and the power and channel setting have reverted back to their default selection.

Any ideas?

Thanks

Anthony

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Trying to Configure AIR-CAP3602i from WLC Not working

Apply vs save configuration

Apply sends to device.

save configuration saves controller config to flash..

Is CleanAir enabled?  It is my understanding that the radios CleanAir routines are then incharge. 

10 REPLIES

Re: Trying to Configure AIR-CAP3602i from WLC Not working

Hi,

what is the AP mode?

Is the issue happening with both radios? Or with b/g radio only?

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"

Trying to Configure AIR-CAP3602i from WLC Not working

We are only looking to configure b/g/n radio's as per our site survey so i haven't done anything with the a/n.

Hall of Fame Super Gold

Trying to Configure AIR-CAP3602i from WLC Not working

I go back to 802.11 b/g/n select my AP and the power and channel setting have reverted back to their default selection.

Did you see the "*" symbol?

Trying to Configure AIR-CAP3602i from WLC Not working

No i didn't.  Screen shots below looking to have AP on Channel 6 with power 3.

After i saved config and went back into 802.11b/g/n radio values have returned to what they were originally, 1 & 3

Hall of Fame Super Gold

Trying to Configure AIR-CAP3602i from WLC Not working

That's odd.  And what is the firmware you are running?

Trying to Configure AIR-CAP3602i from WLC Not working

Firmware Version................................. FPGA 1.6, Env 0.0, USB console 2.2

Hall of Fame Super Gold

Trying to Configure AIR-CAP3602i from WLC Not working

Firmware Version................................. FPGA 1.6, Env 0.0, USB console 2.2

Sorry, that's not the right one.  Look for "Product Version".

Trying to Configure AIR-CAP3602i from WLC Not working

Apply vs save configuration

Apply sends to device.

save configuration saves controller config to flash..

Is CleanAir enabled?  It is my understanding that the radios CleanAir routines are then incharge. 

Trying to Configure AIR-CAP3602i from WLC Not working

Thanks David. 

I feel a bit silly as I never even noticed the Apply button and was too concerned with saving my config changes that I made to the APs so I was only clicking on " Save Configuration".

So once I clicked on the Apply button it took the changes to the channel and power.

Much appreciated and thanks to everybody who replied to my question.

Anthony

Trying to Configure AIR-CAP3602i from WLC Not working

Good catch David. +5.

You want to say "Thank you"?
Don't. Just rate the useful answers,
that is more useful than "Thank you".

Rating useful replies is more useful than saying "Thank you"
2357
Views
10
Helpful
10
Replies
CreatePlease to create content