Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unable to edit config in CLI

After configuring a stand-alone 521AP, I am unable to get to configure mode. I can SSH, login and then get to enable mode. However, "configure" is not one of the available options. My list of available options are attached, as is my sanitised config.

Managing the AP though the WebUI works with no problems.

Stu

  • Security and Network Management
1 REPLY
Hall of Fame Super Red

Re: Unable to edit config in CLI

Hi Stu,

The AP521 is part of the Cisco Mobility Express Solution :(

Q. Can the Cisco IOS command-line interface (CLI) be used to manage the Cisco Mobility Express Solution?

A. Because the objective of the Cisco SBCS was to create a simplified management system and interface for SMB customers, the CLI is limited to troubleshooting (SHO/DEBUG) commands only and cannot be used for configuration.

http://cisco.com/en/US/prod/collateral/wireless/ps7306/ps7319/ps7338/prod_qas0900aecd8060c860.html

Hope this helps!

Rob

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan
166
Views
0
Helpful
1
Replies