Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Unable to get MSE status.

My WCS reported the MSE was disconnected. Then i checked the mse status.

[root@SHWIPS01 ~]# service msed start

Starting MSE Platform

MSE Platform is already running

[root@SHWIPS01 ~]# service msed status

STATUS:

MSE Platform is up, getting the status

Unable to get MSE status. Error: java.net.SocketTimeoutException: Read timed out

Retrying status fetch -

[root@SHWIPS01 ~]#

Any idea or solution about this? thanks a lot.

6 REPLIES

Re: Unable to get MSE status.

Have you tried either of the following:

restarted msed altogether and/or rebooted the appliance?

Can you also provideoutput from the following commands

netstat -tap

ps -ef|grep mcsed

what is the network configuration between the WCS & MSE?

New Member

Re: Unable to get MSE status.

I have tried rebooting the MSE with command

shutdown -r now

or manually power cycle the MSE, but still the same.

MSE and WCS are within the same ip segment, and connect to a same switch.

Re: Unable to get MSE status.

This is as new issue. What version of WCS / MSE?

New Member

Re: Unable to get MSE status.

Hi Lavramov:

My MSE version is 5.2.91.0 and my WCS version is 5.2.110.0

Btw, could you tell me how to verify my license of MSE under this version?

I didn't receive any paper license (PAK)

Re: Unable to get MSE status.

5.2 still works without a license, from 6.0 you will need it.

Contacting your vendor to get a PAK. With the PAK you can get a license from TAC.

This may need further troubleshooting, I have not seen this error message before.

Re: Unable to get MSE status.

-

2265
Views
5
Helpful
6
Replies
CreatePlease to create content