Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

unable to see rouge APs in MSE

Folks,

            I am new to mse. I can see everything on the heat map ( ap's, clients,etc) but i can not see any rouge APs on the heat map. Do I have to do anything in MSE for them to show up. I have checked the grid and selected rouge access points to be shown on the heat map but no luck. Any help would be highly appreciated. The alarms show me numerous rouges in the vacinity but they do not show up on the map.

Parwal

1 REPLY
Silver

unable to see rouge APs in MSE

You need to enable the rogue AP tracking under the MSE configuraiton. Mobility Services -> Click on the MSE you want to configure. Then under the tracking parameters. Remember that each rogue AP counts as a tracked device so if you have a lot of rogues in your area they will take licenses away from tracking your actual clients.

339
Views
5
Helpful
1
Replies