I am testing the Universal briodge feature. When I configure two access points (root/wgb) everything works fine. When I go to the WGB and add the universal command. I get the message that since no clients are associated it will use BVI interface mac address to associate. But, The WGB does not register with the root anymore. When I place it back into the WGB mode by removing the universal command everything starts to work. I do not have any access-list or association filter on the root to permit certain mac addresses.
I upgraded the code and still no luck. WGB works fine but as soon as I put universal keyward with a mac in the end it does not associate with the root. I am running the same code as you on the root and the wgb.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...