Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Update WCS inventory with a replacement WLC

Hi,

We are running WCS Version                                           6.0.181.0 and had a 5508 WLC fail that was connected to this WCS. The WLC was replaced and is running the same config and Software Version                 6.0.196.0.

In WCS the old controller shows up as unreachable which you would expect, but with the new WLC online it does not see it at all. Is there somewhere that I need to change the MAC address or something for WCS to accept the new WLC?

Thanks

Tony

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Update WCS inventory with a replacement WLC

From the WCS, remove the old controller. On the new WLC, make sure that you have configured the SNMP RW community string. Then add the WLC to the WCS with this new SNMP RW community.

Let me know how that goes.

2 REPLIES

Re: Update WCS inventory with a replacement WLC

From the WCS, remove the old controller. On the new WLC, make sure that you have configured the SNMP RW community string. Then add the WLC to the WCS with this new SNMP RW community.

Let me know how that goes.

New Member

Re: Update WCS inventory with a replacement WLC

Thanks for that, this worked OK for me. Should you not be able to just update/audit the new one if it is called the same and has the same IP address therefore allowing you to push out the master config from WCS?

Tony

383
Views
0
Helpful
2
Replies
CreatePlease login to create content