Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

updated 340 security issues

Hi--

i'm trying to use the latest security enhancements to our 340 image (Enhanced MIC verification for WEP, and the Temporal Key Integrity Protocol). But everytime i turn on those new features, the clients associate fine, but IP appears dead (no routing, not passing DHCP req, etc).

any ideas?

3 REPLIES

Re: updated 340 security issues

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: updated 340 security issues

Make sure that your clients are running compatible versions. I have tested and have it working with ACU 5.01, Windows Driver 8.01.06, and Firmware on the cards is 4.25.23. Hope that helps.

New Member

Re: updated 340 security issues

One last thing, it looks like you need to make sure that the wep key is set on the AP before you turn on MIC. You also need to have the Aironet Extensions on before TKIP or MIC will work. Hope that helps.

199
Views
0
Helpful
3
Replies
CreatePlease to create content