Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade my Cisco WLC 2504 to 80.100 and my AIR-LAP1141N-A-K9 radio wont enable

Upgrade my Cisco WLC 2504 to 80.100 and my AIR-LAP1141N-A-K9 radio wont enable.  They Show Admin Status Enable but Operational Status Down.

 

Any Ideas???

3 REPLIES

Similar issue discussed

Similar issue discussed here

https://supportforums.cisco.com/discussion/11236466/access-point-operational-status-shows-down-wlc

VIP Purple

May be this is a bug in 8.0

May be this is a bug in 8.0 specific to 2504. Better to reach TAC & see.
 

Make sure after the upgrade, all wlan are enable status & correctly map to defined dynamic interfaces.

If you have a console output of AP (when it power cycle) then pls attach that as it will tell the reason why radio go into disable mode.

HTH

Rasika

**** Pls rate all useful responses ****

Cisco Employee

This may be of power issue

118
Views
0
Helpful
3
Replies
CreatePlease to create content