Upgrade to WLC code 184.108.40.206 caused TACACS to stop working
I just completed and upgrade of WLC code to 220.127.116.11 and everything is working correctly except TACACS to log into the controller. TACACS was working correctly prior to the upgrade. I am using TACACS to authentication and authorization to the controller for management. This configuration is working on a number of other controllers in the environment but not all controllers are on 18.104.22.168. Are there any bugs or a config change needed to get TACACS working again for controller management.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...