Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgraded outdoor 1310G bridge from Autonomous to LWAPP

I recently got a pair of outdoor 1310G bridge radios to create a bridge. I upgraded one of the APs from Autonomous to LWAPP so that it could connect to our 4402 controller so that it could be monitored and controlled by it.

Everything looks like it upgraded fine with the upgrade tool never got any errors however the file: Config_18June2009_95613.csv that is suppose to have a hash key so that I can load that into the WCS or directly into the WLC is blank nothing is in that document. So at the moment the AP is not joining up with the WLC. Anybody have any advice?

Thanks,

Ryan

1 REPLY
Cisco Employee

Re: Upgraded outdoor 1310G bridge from Autonomous to LWAPP

Hi Ryan,

You can run 'debug pm pki enable' when the AP is trying to join to find out the hash key.

-Matt

138
Views
0
Helpful
1
Replies
CreatePlease to create content