I have built up a network in the following fashion .
Connected 1231 G to a 2950 G switch, port 3 is connected to DHCP server.On the Receiving end i have connected one 1121 G to 2950 Switch on port 1 and configured the same in Workgroup Bridge Mode , and i am receiving Ip from any of the ethernet ports of the switch, however when i connect one more access point to the second switch the Access point does not give IP to the clients.
Is it possible to use this kind of setup or else any change is to be done to receive Ip on the clients.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...