I just updated to WLSE 2.15.1 so I could use it to push out the 12.3(8)JEC IOS out to all of my 1210 AP's. While setting up the job, the WLSE gives a waring that the IOS I selected may not be for the AP I selected. I have confirmed that the IOS is the correct one for the AP. What gives?
It's the WLSE saying it doesn't recognise the IOS version as one it knows of and because of that it advised you that it might cause the AP to fail. If you've verified the IOS version matches the AP then you can safely ignore the message.
I figured as much. However, I just updated WLSE with 2.15.1 which is supposed to recognize that IOS. Maybe the 2.15.1 isn't all that it is cracked up to be. However, I did deploy the IOS in the middle of the night and everything went fine.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...