I am testing using multiple VLAN's on Aironet 1200s and 350s. I keep getting a warning that reads: "No VLAN should be selected when Proxy Mobile IP is enabled under SSID 1 of interface 2". The proxy Mobile button is not enabled in this particular VLAN. Why do I keep getting this warning?
I could not find that bug in the bug toolkit. I have another question: My guest VLAN will not pull an IP address form the DHCP server. It gets assigned a 169.254.x.x address. I followed the Documentation "Configuring VLANs" that CIsco reccommends, but i still can not get my guest VLAN to work. ANy ideas would be appreciated
Same problem here. First remember if you get a 169.254.x.x ip address that is a default address when a nic / radio can't obtain an IP. Maybe my config which is not working 100% can help you fix your setup...I have two vlans: VLAD 8 is guest ssid and I set it to Native and VLAN 9 is set to ssid biz. When I connect to the guest vlan I can an IP address from my DHCP server and life is good. However, when I connect to the biz ssid i get the old 169.x.x.x address and I can't connect anywhere. TAC tells me its the switch then they tell me its the AP (back and forth) over the past 3 days. Also the error message you get is just a warning. No worries on that unless you have mobile ip on. its in the latest user guide and release notes.
I'm replying to a really old thread here (4 months!), but hey!
First, I reckon your inter PC thing could be a faulty AP, or buggy code. I had the same thing once and it was a faulty AP, but I'm sure I saw the same thing on a certain code too.
On the "No VLAN should be selected when Proxy Mobile IP is enabled under SSID..." topic, I currently have the same issue. My native VLAN isn't associated to a SSID, so it's not that. I've tried multiple codes, so its not that either.
My config is "by the book" as far as I can tell.
I was looking on here as a last ditch on this.
All-be-it only a warning, its annoying, and it shouldn't be there! If anybody is reading this at Cisco, and you could suggest what might cause this? It would be appreciated! Otherwise, I'm logging a TAC case tomorrow!
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...