Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
Is it possible to configure a VTP from one switch to another over an 1300 Bridge?
The only sample i've seen at cisco.com is the one with only the vlan 1 being transmitted.
The sample with multiple Vlans is for Access Point and wireless clients not for a bridge.
The way I'm doing it is configuring multiple SSIDs each with one vlan and putting each subinterface of radio 0 in the same "Bridge-group" of the subinterfaces of fastethernet0.
Is this the only way to do that?