In my ciscoworks I have some vtp views but my access-point is in the view NO_VTP. I would like to place in the company vtp domain but this doesn't seem to work . I don't have any commands , there is no vlan database on the AP ?
Unfortunately VTP is not supported on IOS AP's. You have to manually create VLAN's on the AP. Even though I love CLI as much as the next guy the easiest (I mean a lot easier) way to do this is through the GUI. Go to Services -> VLAN
They don't have to match numerically but would be best practices if you did. Only SSID's associated with VLAN's will allow wireless clients to associate on version 12.3.7 or higher.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...