WAP4410N reports iPad WiFi MAC address as illegal.
When I try to add my iPad to the "Wireless Connection Control" section, the MAC address i enter is rejected as being illegal. I updated from firmware 188.8.131.52 to 184.108.40.206 and it had no effect. I have tried adding it with and without the delimiters. I have indicated the iPad's wifi address below. The iPad connects OK if I turn off the MAC address filtering, but I would like to keep this security feature active. Can anybody help me?
7C:6D:62:D6:B7:75 - iPad address.
The error message reads: "MAC 10 must be 12 Hex chars (0~9 and A~F) with optional delimiters (: or -), and the second bit is not a odd number"
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...