Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

watchlist on 4.1.181.0 - where'd it go!?

(Cisco Controller) >show watchlist

Incorrect usage. Use the '?' or <TAB> key to list commands.

(Cisco Controller) >config watchlist enable

Incorrect usage. Use the '?' or <TAB> key to list commands.

I can't find any references that this feature set might have been discontinued, and it still appears in the command reference guide.

A command listing on the controller gives:

(Cisco Controller) >config ?

802.11a Configures 802.11a parameters.

802.11b Configures 802.11b parameters.

802.11h Configures 802.11h parameters

.

.

.

sysname Configures the system name.

tacacs Configures TACACS+ Servers.

time Configures system time or servers.

trapflags Enable or Disable trap flags that apply to the switch.

wlan Configures the Wireless LAN Network.

wps Configures WPS settings.

1 REPLY
Silver

Re: watchlist on 4.1.181.0 - where'd it go!?

As far I know this command is supported on 4400 series and 4100 series command .

http://cisco.com/en/US/docs/wireless/controller/4.1/command/reference/cliapp.html . you can try to upgrade or dwongrade the code and see if that works.

114
Views
0
Helpful
1
Replies
CreatePlease to create content