I added a new AP to a map & thick wall. So I ran the "recompute RF prediction" & it alerted me that 1 of the existing AP in the middle of the map has an "unknown" antenna type. All the APs are 3502i so what I am trying to figure out is how to correct this particular APs antenna type so it will compute RF properly.
I have done some google & forum checking but not found a specific replica or fix for whatever I did.
Thanks in advance for your time & input.
Added image to show 1 AP correctly & the incorrect AP antenna.
Both are same 3502i, same location, same WCS, same WLC.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...