I have WCS 5.X running with trial license until our we receive our purchased license. Our 2710 AL came in and I have it up and running and known to WCS. I have a couple getting started questions.
Not sure what the https enable is for on the AL? I did a google earth map of our campus. Started to try and place buildings on the map. Once you place a building can you move or edit its size or location. Didn't see a way.
What general steps should I be taking to putting all this together with the WCS and AL? I'm getting floor plans for each building from our physical plant department. Do they sized or edited? I have placed a few APs on each map. Can the AL help in locating the APs on the maps. General stuff to start getting the most out of the software. Been reading what docs I have found.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...