Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCS and CLI displays different

We are setting up our first wireless system using 4402s and AP1010s. However, we have noticed that if we configure the 4402 via the WCS, the changes are not seen by the CLI and vice versa. (Saves are being made!) For example, I configured an interface called users via the WCS but it is not seen via the CLI, and I have set up an interface called wire-users via CLI which is not seen from the WCS.

Is this a known bug/issue?

The WCS is v3.0 and the 4402 is running AireOS v3.0.107.0

1 REPLY
Silver

Re: WCS and CLI displays different

Yes, This is a known issue. Try using either the CLI or the GUI to do the configuration.

115
Views
0
Helpful
1
Replies
CreatePlease login to create content