WCS and WLC getting out of Sync and Disabling WLANS
This is a bit weird. I have WCS running on Linux, version 5 and 6 have done the same thing where it will run fine but for no apparent reason the WLC will disable all the WLANs on the controller. This seems to happen across 4.x and 5.x controllers. If I go into WCS is shows the WLANS enabled, executing an audit shows the wlans are disabled and resyncing with the WCS db fixes it, but then it will happen a day or so later.
Re: WCS and WLC getting out of Sync and Disabling WLANS
The weird thing is we have about 5 WLC and they all seem to do it. I was wondering if it is in fact the WLC or the WCS because it seems to happen on all controllers, some more then others. I was thinking there may be some kind of shutdown mechanism if the controllers experience some kind attack, like a DOS attack or a flood attack. We have wireless all around these AP's/controllers from homes and the City.
I have removed them from WCS to see what happens and I will let you know, if anyone else has an idea I am up to trying it:)
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...