Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WCS and WLC

I need to change the name on about 200 recently installed access points. I have an Excel file with the MAC addresses and new naming convention. Is there a way to import this file into the WCS or WLC to make this task easier?

Thanks

Mike

1 REPLY

Re: WCS and WLC

Yes, but it is quite painful

I posted a script in the forum that will allow you to do this

Here is the link:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc17d78/1#selected_message

You will need to build a flat file that has an entry per ap with the syntax per line

config ap name

The script was written for linux, but may work in other OSs with perl and expect

It will take some experimenting to tweak your variables, but it should work.

The posted script is for pulling info off the controller without snmp

I am still waiting for Cisco to put an IOS-like CLI on the controllers to make scripting easier.

133
Views
0
Helpful
1
Replies
CreatePlease to create content