Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

WCS Authentication with RADIUS Microsoft NPS

Hi

I'm running WCS 7.0.220.0.

  • I would like to authenticate users that are able to logon the WCS, through MS Network Policy Service (RADIUS).
  • I would like all my domain users to be member of the local group on the WCS "Lobby Ambassador", so all domain users has access to generate guest access accounts, for the web auth...

I can see under the WCS Administration under AAA that it should be able to use RADIUS - but i'm not sure how to setup the NPS policy, can you guys guide me?

Best Regards,

Steffen.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: WCS Authentication with RADIUS Microsoft NPS

IAS and NPS will be the same for the most part.  Here is a link how to setup WCS using IAS for management.  Of course you would change it for lobby admin.

http://mihai.radoveanu.ro/2010/11/configuring-the-radius-authentication-with-cisco-wireless-control-system-6-0-196-0/

https://supportforums.cisco.com/thread/339057?tstart=0

http://www.cisco.com/en/US/products/ps6305/products_tech_note09186a00809038e6.shtml

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

Re: WCS Authentication with RADIUS Microsoft NPS

IAS and NPS will be the same for the most part.  Here is a link how to setup WCS using IAS for management.  Of course you would change it for lobby admin.

http://mihai.radoveanu.ro/2010/11/configuring-the-radius-authentication-with-cisco-wireless-control-system-6-0-196-0/

https://supportforums.cisco.com/thread/339057?tstart=0

http://www.cisco.com/en/US/products/ps6305/products_tech_note09186a00809038e6.shtml

-Scott
*** Please rate helpful posts ***
2161
Views
0
Helpful
1
Replies
CreatePlease login to create content