we currently have to postion about 200+ access points in the WCS to generate heat-maps for a lot of floors. Does anyone do have some tipp to "bulk operate" this task? Using the WCS webgui adding the aps step by step ends up a huge workload. Would be glad if there would be an easier way... checked also the documentation but didn't found anything yet.
Thanks for your quick response. So far it's also clear for me, we are using WCS and allready managing quite lot of aps, but I was wondering if everybody is placing all aps step-by-step... I have detailed geographic position data for every ap (and could convert it to relative postions). May be there will be some CSV like import function in the future.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...