WCS: Changing default settings for Lobby Admin's authorized through ACS
I have a setup where lobby admins are authorized based on AD group via Cisco ACS. I like to remove the remove or change the default settings so that a secretary should not see og change this. I can easyly change this for local admin users, but not users validated via WCS and LDAP.
Re: WCS: Changing default settings for Lobby Admin's authorized
If the same user exists both locally as well as in the RADIUS server but with different access privileges, then the WLC authenticates the user with the privileges specified locally. In other words, local configuration on the WLC always takes precedence when compared to the RADIUS server (ACS).
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...