Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

WCS; No data from SE's, but all reachable

                   Hello,

The WCS is 7.0.230.0 and the remote Spectrum Expert clients are 4.1.11 linked to remote sensors: 3502's w/7.0.116.0 and 3602's w/7.2.103.0 code.

The WCS shows the various SE's as reachable and I can select which ever I wish.  However there is never any data to display.

If I log on to the SE client device (laptop or desktop) I see all the noise and junk the remote hears.

If the remote sensor is in Local mode one only sees the specific channel the ap is on.

If the remote sensor is in Monitor or dedicated SE Connect mode one can see the whole spectrum, noise and interference.

But nothing appears at the WCS.

I do notice that with an SE in remote mode, there is no SSID/packet information.  i.e. Wireless LAN Card Not Detected.  One would think that the AP still had its paket ear on even when the SAGE chip was active.

Thank you..

David

337
Views
0
Helpful
0
Replies