I need to increase the AP license for the WCS. As I review the process, it looks pretty simply. However, after uploading the license it says to reboot the WCS.
I don't see any menu selection on the WCS to reboot it. I could always perform a hard reboot, except that the WCS is physically located in a different location and I prefer not to travel to that site if I can avoid it. Is there a way to remotely reboot it ?
firstname.lastname@example.org =========== It takes an Act of God to fade a wireless path, but any fool with a backhoe can cut fiber ==========
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...