I have a strange problem. Under Monitor/devices/Access Points: I can search for an access point I have been having problems with. When I click on the B/G radio, the next page indicates three WLANs. HOWEVER, under the Configure/Access Point menu, only the two SSIDs I want are shown. I performed a reset on the AP. That did not work, so I performed a Clear Config. That did not work either. I shut the port and re-enabled it. When I run a network scan with Netstumbler or even just a laptop, I have four 1131AGs that broadcast an SSID I do not want broadcast. Any advice is appreciated.
How many WLAN do you see on the controller. Sometimes what can happen is, if the WLC and the WCS are not synchronized, the parameters may show differently on the WCS and the WLC. Make sure you have synchronized the WLC and WCS.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...