Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WCS throws error while adding WLC

Hi Guys.

I am trying to add a couple of 4402 WLC's to a WCS 5.0 .However on entering correct snmp parameters it throws the following error:"Failed to add device to WCS REASON: Object not found in device"

2 REPLIES

Re: WCS throws error while adding WLC

Hi,

This is probably a version mis-match between WCS & WLC codes. Check the release notes for the software your running to ensure the versions are compatible.

New Member

Re: WCS throws error while adding WLC

Hi RitJonAtk

it is indeed a version mismatch, checked the release notes to confirm that. I was using WCS 4.1 with WLC 5.0 .

Thanks a lot....u saved some precious time (& blushes)

Regards

178
Views
0
Helpful
2
Replies
CreatePlease to create content