Setting up a WLAN to use LDAP. I've read throught the configuration guide with little help. I was hoping to see if the community can assist. What I'm looking to do is use LDAP (AD) groups to get the VLAN that they work for. For example, account (group) when logged into wireless would be connected to the interface setup for the accounting department - VLAN1 (10.1.2.x). Where as a user from the Legal department logs into the system and gets an IP from the Legal Vlan (VLAN2 - 10.1.3.x).
I know that this works using ACS. Unfortunately our ACS is outdated and the appliance is on its last leg. Any help would be appreciated.
I can't speak for LDAP specifically, but if you use RADIUS (MS IAS is free), you can define the Cisco VSAs needed to assign VLANs. A good if not old writeup is at the URL below. I believe it is for the most part still accurate.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...