Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WCS/WLC Disabled WLAN still broadcasts! BUG?

Versions 6.0.182.0 on controllers (4 WISMs) and 6.0.132.0 on WCS.

Created a test WLAN which was used for a week or so, WPA2/PSK, broadcast ssid, standard stuff. I no longer wish to use it and set the enabled state in the template to disable and then saved and applied the template to the controllers. On various devices, I can still see it broadcasting! I have even checked on the individual controllers and the WLAN is set disabled, so no WCS sync issue. I also tried switching the broadcast ssid to off and reapplying it and this makes no difference.

If I try to connect to the WLAN, this fails, which is obviously a good thing! I have not tried to delete it yet as there are situations where we need the ability to enable/disable wlans.

Anybody else seen this issue before I report it to TAC?

1 REPLY
Bronze

Re: WCS/WLC Disabled WLAN still broadcasts! BUG?

If the WCS and WLC has been synchronized, you should not see this issue. Since you have already verified and ruled out a sync issue, this looks like a bug.

125
Views
0
Helpful
1
Replies