We are a fairly large campus with approximately 150 AP's. Currently we are NOT lightweight and have deployed WDS's to locations under the 'recommanded/required' standards.. However, it seems that our WDS's seem to constantly authenticate to the ACS server for AP authentication, not user. They pass on authentication, but it seems to be constant and it fills up the logs and makes it a mess to dig through them for other issues. Is there a time out that can be upped on authentication for this?
Any idea where this option is located. I've looked over the WDS doc before and again just now. It mentions the reauthentication interval (though I think it may only apply to clients) but I don't see where it says to adjust the setting.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...