I am not sure if this is the correct place to ask the following questions, but here it goes...
As part of a wireless pilot project we have installed 50 access points (Cisco aironet 1231G) in a couple of buildings. The real project once approved could scale to over a 1000 units. We are also trying a Cisco WDS1030 with the WLSE management tool. The WLSE seems to be a good configuration and troubleshooting tool. To keep things simple for our computer center operators we would like to send the traps we configure in WLSE to our Netview server as snmptraps to be displayed as alarms. Sending the traps is simple, but which would be the right procedure to correlate these traps in Netview??? I dont want to just read the trapd.log and react on the information there, instead I would like to have more flexibility by using the correlation facilities from Netview which is the way we are alarming on snmptraps send by different type of devices with network connectivity (ups, environmental units, sensors, switches, servers, routers, etc)
I like the centralized approach of using WDS devices to monitor several access points at once and send snmptraps from just a device instead of 50 access points.
In summary I would like to know:
Which snmp mibs/traps need to be loaded in Netview to process the traps sent by the WDS unit???
Once I load the traps, I guess I can correlate based on the trap ID the same way Im correlating other traps.
If there is no a particular mib/trap ID for the traps sent by the WDS, How can I then correlate them once the reach the Netview server????
If someone is doing something similar, please send me a note.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...