Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Web access doesn't work for AP1231

When I set up a username with privilege level 15 the web prompt just keeps blinking back at me. I can log on via telnet with no issues using the username and it puts me right into enable mode without the enable password. This problem happens with just about every autonomous WAP I set up. The web prompt says the username must have privilege level 15 but refuses to allow usernames with privilege level 15.

Any ideas?

2 REPLIES
Hall of Fame Super Gold

Re: Web access doesn't work for AP1231

Can you post the config please?  What is the JAVA version?

New Member

Re: Web access doesn't work for AP1231

I've attached the config. Looking at the Sun Java Console I think the version is 1.6.0_06.

285
Views
0
Helpful
2
Replies