Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

web authentication login page

Hi, 

i have configured my wlc for the web authentication, now work fine. But for the login page i must insert manual te virtual ip of the WLC (1.1.1.1).

There is a method that when you connect to the SSID the web page is displayed automatically? 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

What code of WLC version are

What code of WLC version are you using ? Also make sure opening web page is http & not https (normally most of sites, like google, automatically use https & those won't redirect)

Also check your DNS to make sure it properly resolve URL. Also try by adding a DNS entry for 1.1.1.1 IP as well.

Here are some reference WebAuth config example which may help you as well

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/69340-web-auth-config.html

 

HTH

Rasika

*** Pls rate all useful responses ***

6 REPLIES
VIP Purple

Webpage not displayed when

Webpage not displayed when you connected to it. (client state would be WEB_AUTH_REQD)

You have to open a web browser & then it should redirect to login page. If you have configured WebAuth then user has to enter the credentials. If you have configured Web passthrough then no username verification (you can include enter email ID as an option). Then only client will be in RUN state.

Refer this for different webauth configuration options

http://mrncciew.com/2013/03/21/wlc-web-authentication/

HTH

Rasika

*** Pls rate all useful responses ***

 

 

New Member

Hi Rasika,i configure the

Hi Rasika,

i configure the WebAuth but when i open the browser I'm not redirect to the login page, but if i enter the virtual ip the web page as shown.

 

Thanks

VIP Purple

What code of WLC version are

What code of WLC version are you using ? Also make sure opening web page is http & not https (normally most of sites, like google, automatically use https & those won't redirect)

Also check your DNS to make sure it properly resolve URL. Also try by adding a DNS entry for 1.1.1.1 IP as well.

Here are some reference WebAuth config example which may help you as well

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/69340-web-auth-config.html

 

HTH

Rasika

*** Pls rate all useful responses ***

New Member

Hi Rasika,

Hi Rasika, Sorry for the late replay, Thanks for the support, the problem was that i try to open a https page. There is a method for redirect however when i open a https page? Thanks again, Dino
VIP Purple

https redirect works from WLC

https redirect works from WLC software 8.0.x onward. Here is the 8.0.100.0 release notes of that code specifying this

http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn80.html

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Fine, then now I upgrade the

Fine, then now I upgrade the wlc.

 

thanks again

122
Views
10
Helpful
6
Replies
CreatePlease to create content