What is a "Rogue Client" when there is only open access
This may seem like a basic question, but how can there be "Rogue Clients" if the system is setup for open authentication?
Is this even possible?
I am asking this because two Rogue Clients have appeared in the system and it is unclear what these are. Is client that connects to a rogue ap considered a "rogue client"? This does not seem to be defined anywhere in the documentation that I have found.
In the Cisco Wireless LAN Controller Configuration Guide, it does make one reference to "Detect trusted clients on rogue APs..........Alarm Only".
However, we do not have a list of "trusted users" loaded. Does the WLC assume that if a client once connected to it and then connects to another "rogue" AP that the client now becomes classified as "rogue"?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...