We had a strange problem after installing a 4402 controller and several new 1131 LWAPP ap's.
Many of ours clients did not receive ip when trying to connect to the network. Then we discovered an older ios ap powered on. When we powerd this ap off, the clients got their ip in a few seconds. It seemed very strange.
So, if the controller discover a rough ap, what settings do you recommend for status settings.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...