When I connect to ASA from L2 S/W using IPSEC Tunnel .

[syjeon]

Hi.

When I connect to ASA from L2 Switch using IP sec Tunnel, I invocked the cli command, the session hang up, and then I can't L2 Switch , If I want to connect to L2 Switch again, I must reload L2 Switch.

Is this a ASA Security function?

I attached the configuration my customer site. the public ip was deleted due to security issue.

P.S What is a below command?

threat-detection basic-threat

threat-detection statistics access-list

[mchin345]

To view the threat detection configuration, use the show running-config threat-detection command in privileged EXEC mode.

show running-config [all] threat-detection

option : all -- (Optional) Shows all threat detection commands, including the commands you have not changed from the default. For example, you can view the default rate limits for the threat-detection basic-threat command.